Coil covers can be a problem ??
Moderator: Daniel
- mhonzell
- Administrator
- Posts: 2181
- Joined: Mon Jul 22, 2013 2:14 pm
- Location: Missouri
- Has thanked: 2 times
- Been thanked: 9 times
- Contact:
Re: Coil covers can be a problem ??
In the first photo, you are looking at the side of the hinge that would be against the wood. Another nail would be installed near the top (as shown below). The square nail heads would be on the inside of the box with the hinge plate on the outside. A smaller piece would be connected to a non-moving part of the box, but similarly flat since this is not designed to wrap over a corner edge. Nowadays, we use screws that penetrate from the outside of the hinge.
-
- Forum Supporter
- Posts: 1818
- Joined: Sat Sep 21, 2013 6:08 pm
- Has thanked: 58 times
- Been thanked: 14 times
Re: Coil covers can be a problem ??
I've got to admit I almost jumped out of my chair when I thought Mark found a complete example of my hinge.
Then I realized he added the second nail for demonstrating how it would look with both nails.
I keep going back and forth in my head whether it was for a jewelry box or not. It seems big for a dainty jewelry box. I'm pretty sure it was meant to be on the water tho because of the bronze composition.
Hopefully one of these days I'll come across something similar that will give me a clue
to what it was used on.

Then I realized he added the second nail for demonstrating how it would look with both nails.

I keep going back and forth in my head whether it was for a jewelry box or not. It seems big for a dainty jewelry box. I'm pretty sure it was meant to be on the water tho because of the bronze composition.
Hopefully one of these days I'll come across something similar that will give me a clue

Last edited by PetesPockets55 on Thu Jul 26, 2018 6:44 am, edited 1 time in total.
- Daniel
- Administrator
- Posts: 13249
- Joined: Wed Jan 28, 2009 4:59 pm
- Location: Ohio
- Has thanked: 50 times
- Been thanked: 97 times
- Contact:
Re: Coil covers can be a problem ??
My confusion is the head of the nail being inside the chest, was not thinking in that direction. lol
- mhonzell
- Administrator
- Posts: 2181
- Joined: Mon Jul 22, 2013 2:14 pm
- Location: Missouri
- Has thanked: 2 times
- Been thanked: 9 times
- Contact:
Re: Coil covers can be a problem ??
The tip of the nail was pounded down to act as a rivet head holding the plate in place.
- Daniel
- Administrator
- Posts: 13249
- Joined: Wed Jan 28, 2009 4:59 pm
- Location: Ohio
- Has thanked: 50 times
- Been thanked: 97 times
- Contact:
Re: Coil covers can be a problem ??
I understand that but the head of the nail being inside the chest is where my confusion came in. Wasn't visualizing until you posted the "complete" hinge.